Installation manual

6
ASWC-1 Installation
Connections to be made
Onceyouhavecollectedorprintedoutthe“ASWC-1VehicleInstructions”
foryourparticularvehicle,fromwww.axxessinterfaces.com,you’reready
toinstalltheASWC-1.
Note: If wiring is not available on our website for your vehicle, you will
need to obtain this yourself. Please check first with Axxess Tech Support
department at 1-800-253-TECH, as we may have this information.
Into vehicle:
1) ConnecttheBlackwireoftheASWC-1totheground.Youmayuse
thesamegroundingpointastheaftermarketradio;but
it is highly recommended to ground the ASWC-1 to the chassis,
of the vehicle, by itself.
2) Withthekeyintheoffposition,connecttheRedwireoftheASWC-1
tothe12-voltaccessorywire.
3) Locatethecorrectsteeringwheelcontrolwire(s)inthevehicle’s
harness,asdescribedinthe“ASWC-1VehicleInstructions”.Connect
thesewirestotheASWC-1.
Note: Metra recommends that the wires are soldered for
the best and most secure connection. Tapping style connectors
are not recommended due to a higher chance of a intermittent
connection or change in resistance values (which will cause the
ASWC-1 to fail to program).
Into radio:
1) Fortheradioslistedbelow,plugtheincludedfemale3.5mmadapter
(withtheBrownandBrown/Whitewires)intothemale3.5mm
connectoroftheASWC-1harness.
A. For Eclipse radios:ConnecttheEclipsesteeringwheelcontrol
wires(normallyBrownandBrown/Black)totheBrownand
Brown/WhitewiresoftheASWC-1.TheBrownoftheASWC-1
goestotheBrown/BlackoftheEclipseandBrown/Whiteofthe
ASWC-1goestotheBrownoftheEclipse.