Installation manual

B. Radio LED Feedback (indicatedbyRedLEDontheASWC-1)
1st LEDflashisforEclipse(Type1)
2nd LEDflashisforKenwood
3rd LEDflashisforClarion(Type1)
4th LEDflashisforSonyandDual
5th LEDflashisforJVC
6th LEDflashisforPioneerandJensen
7th LEDflashisforAlpine*
8th LEDflashisforVisteon
9th LEDflashisforValor
10th LEDflashisforClarion(Type2)
11th LEDflashisforMetraOE
12th LEDflashisforEclipse(Type2)
13th LEDflashisforLG
14th LEDflashisforParrot**
15th LEDflashisforXITE
*Note (section B): If the ASWC-1 flashes 7 times and you do not have an
Alpine radio connected to it that means that the ASWC-1 did not see any
radio connected. Verify the 3.5mm connector is connected to the steering
wheel control input into the radio.
**Note (section B): The AX-SWC-PARROT is required (sold separately).
The radio must be updated to rev. 2.1.4 or higher from www.parrot.com
and ASWC-1 must be updated to the latest firmware from
www.axxessinterfaces.com.
23
ASWC-1 Troubleshooting
LED Feedback