Installation manual

20
4) Next,pressandholdtheVolume Downbuttonuntilthe
LEDgoessolid.ReleasetheVolume Down buttonandtheLED
willturnoff;Volume Downhasnowbeenprogrammed.
5) AtthispointrefertheManualProgrammingLegend(p.21)and
continuetotheSeek Up/Nextbutton.
Note: For any command that needs to be skipped, press the
Volume Up button for each one. The LED should light up each time
you press the Volume Up button.
6) Afterthelastbuttononyoursteeringwheelhasbeenprogrammed,
pressandholdtheVolume UpbuttonuntiltheLEDflashesslow;and
thenreleasetheVolume Upbutton.
Note: If at any time an error is made hold down the reset button on
the ASWC-1 for 10 or more seconds. This will restart the manual
programming. Go back to Step 4 and start again.
7) PressandholdtheVolume DownbuttonuntiltheLEDstartsto
flashquickly.
8) ReleasetheVolume Downbutton.
9) Afterapproximately4secondsoftheLEDflashingquicklytheLED
willgooutfor2seconds.
10) ThentheLEDwillflash,upto15times,dependingonwhatradio
isconnectedtotheASWC-1.
11) Makesurethenumberofflashesmatchwhatradioyouhave
installed.RefertotheRadioLegend(p.13).
Note: If the number of flashes do not match the radio you have
installed, refer to the Changing Radio Type section (p. 13).
ASWC-1 Troubleshooting
Manual Programming Mode