Installation manual

19
ASWC-1 Troubleshooting
Manual Programming Mode
IfyourvehicleisnotlistedforautodetectionbytheASWC-1on
theAxxesswebsite,www.axxessinterfaces.com,youmaybeableto
manuallyprogramanon-datacommunicationvehicleusingthe
followingsteps.
Tip: If you do not know if you have a data communication
vehicle or not, refer to the “ASWC-1 Vehicle Instruction” document,
from www.axxessinterfaces.com. If it indicates to press and release
the Volume Up button repeatedly to program the ASWC-1, then you
have a data communication vehicle.
Note: Not every radio will have all the possible steering wheel
control commands on the steering wheel. Aftermarket radios that
do not have Bluetooth will not recognize the PTT (Push to Talk) or
On/Off Hook commands, however these buttons may be able to be
manually programmed to do other commands. Please refer to the
radio owner’s manual or radio vendor for specific commands that
the radio will recognize.
Note: Please read all Manual Programming Steps before beginning.
1) FollowthestepsintheConnectionstobeMadesection(p.6-7)to
wireuptheASWC-1toyourradio.
2) Turntheignitionon,thenpressandholdtheResetbuttononthe
ASWC-1forapproximately10secondsuntiltheLEDontheASWC-1
flashesslow;andthenreleasetheResetbutton.
3) Atthispoint,pressandholdtheVolume Upbuttononthesteering
wheelfor7secondsuntiltheLEDgoessolid.Nowreleasethe
Volume Upbutton,andtheLEDwillgooff. Volume Uphasnow
beenprogrammed.