Installation manual

18
3) For Kenwood radios,makesurethattheASWC-1displaysthata
Kenwoodradioisbeingused;referencetoRadioLegend(p.21).If
theRadioLegendshowsaJVCradioinstead,thenreferencetothe
ChangingRadioType(p.12)toforceprogramtheASWC-1to
displayKenwood.
Tip: Some Kenwood radios have a feature called Remote Sensor. If
your radio has this feature, ensure it is turned on. If it is on, turn it
off, then back on.
4) For Alpine radios,removethe3.5mmjackfromtheradio,
reprogramtheASWC-1withthejackremoved,andthenreconnect
the3.5mmjackbackintotheradio.
Tip: Some Alpine radios have a feature that turns the remote to
either the back, or the front. If you have one of these radios, ensure
the sensor is on the rear setting. If the setting is on the rear, turn it
to the front, then back to the rear.
5) For Pioneer and Sony radios,iftheASWC-1works,butthebuttons
areoutoforder,orbecomeoutoforder;thiscouldbecausedbythe
3.5mmjackontheASWC-1notseatingproperly,slippingout,ordirt
onthecontacts.Additionally,sometimesthiscanbeintermittent.
Removeanydirtonthecontacts,reinsertthejackfirmlyintothe
radio,andthenputastresslooponthe3.5mmcabletopreventthis
fromhappeninginthefuture.Also,ifanythingisprohibitingthejack
fromseatingallthewayin,suchasaheatsink,lightlytrimsomeof
theplasticfromthe3.5mmjackasneeded.
ASWC-1 Troubleshooting
Auto Detect Mode