Installation manual

17
ASWC-1 Troubleshooting
Auto Detect Mode
Note: If a pre-wired harness is being used and you have tried all the
troubleshooting steps listed above, if the ASWC-1 still does not go
to a solid LED, remove the pre-wired ASWC-1 harness and use the
harness that came with the ASWC-1.
Ifyouhaveperformedanyofthestepsabove;reprogramtheASWC-1
bypressingtheresetbuttonontheASWC-1for3seconds,release,and
thenfollowtheinstructionsonp.9, startingfromStep3.IftheASWC-1
stilldoesnotgotoasolidLEDattheend,pleaserefertoManual
ProgrammingModeonpp.19-21tomanuallyprogramtheASWC-1.
IftheASWCdidgotoasolidLEDbutstilldoesnotwork,followthese
stepstotroubleshoottheradioprogrammingportionoftheauto
programmingsequence:
1) Confirmthatthe3.5mmjackonASWC-1isconnectedtoyour
radiosecurely,andinthecorrectjackoftheradio.Makesureitis
notpluggedintotheBluetoothmicorAUXjack.Ifyouarenotsure
whatjacktoconnecttotheradio,pleasecontacttheradiovendor.
Ifthewrongjackoftheradiowasconnectedto,correctit;andthen
reprogramtheASWC-1.
Note: Some radios do not use a jack for the steering wheel controls,
instead they use a wire. If so, reference Connections to be Made (p.
6), and ensure that you have the proper wire(s) connected.
2) Ifyouareusingaradiowithawireforconnectionsinsteadofajack,
makesureyouhavealsoprogrammedthesteeringwheelcontrolsto
theradiofollowingtheinstructionsincludedwiththeradio.Contact
theradiovendorifyouhaveanyquestionswiththis.
Note:
This does not apply to JVC and Kenwood radios.