Installation manual

12
1) After3secondsofturningthekeyon,pressandholdtheVolume
DownbuttononthesteeringwheeluntiltheLEDontheASWC-1
goessolid.
2) ReleasetheVolume Downbutton;theLEDwillgooffindicatingwe
arenowinChangingRadioTypemode.
3) RefertotheRadioLegend(p.13)toknowwhichradionumberyou
wouldliketohaveprogrammed.
4) PressandholdtheVolume UpbuttonuntiltheLEDgoessolid,then
release.Repeatthisstepforthedesiredradionumberyouhave
selected.
5) Oncethedesiredradionumberhasbeenselected,pressandhold
theVolume Downbutton,onthesteeringwheel,untiltheLEDgoes
solid.TheLEDwillremainonforabout3secondswhileitstoresthe
newradioinformation.
6) OncetheLEDgoesofftheChangingRadioTypemodewillend.You
cannowtestthesteeringcontrolwheelcontrols.
Note: If at any time the user fails to press any button for a period
longer then 10 seconds this process will abort.
ASWC-1 Installation
Changing Radio Type