Installation manual

axxessinterface.com 800.221.0932
* If the ASWC was installed in a vehicle before:
2)Turntheignitionon,theledwillashslowly
3) Hold down the reset button for more then 2 seconds but less then 10 seconds, the led will start
ashingrapidly
4) Perform action required for your particular vehicle as noted in the vehicle info sheet
5)Afteracoupleofsecondstheledshouldstopashingandnotlightupfor2seconds.Atthispoint
do not push any buttons.
6)Afterthe2secondstherewillbeaseriesof7ashes,someshortandsomelong.
7)Theledwillpauseanother2secondsthenaseriesof9ashes.
8) This is the end of the auto detection stage. If the ASWC detected the vehicle and the radio
successfully the led will light up solid red.
9) Make sure the steering wheel control buttons function correctly in the vehicle and enjoy your radio.
So what if the led does not light up solid red or the steering wheel controls is not working correctly
with the aftermarket radio?
Check out troubleshooting section right below.
Troubleshooting the Auto Detect Mode
Soyoutriedtheautodetectfeatureandattheendtheleddidnotstayonsolidred,itstartedashing.
That means the ASWC did not detect the vehicle. Follow these couple steps to determine what hap-
pened:
First some basic steps:
1) Verify that you have 12 volt accessory and a good ground to the ASWC.
2) Verify with the vehicle information sheet on the Axxess website that you connected the correct
steering wheel control wires in the vehicle to the correct wire(s) on the ASWC.
3) Verify that the 3.5mm connector is connected to your radio securely and in the correct location.
4) If using the female 3.5mm connector on an Eclipse or Kenwood radio, verify that the radio’s SWC
wire is connected to the correct wire on the ASWC.