Installation manual

9
2) Turntheignitionon;theLEDwillstartflashingredrapidlywhichmeans
theASWC-1islookingforthevehicleandtheradio.Gotostep4.
--- Or ---
IftheASWC-1wasinstalledinavehiclepreviously:
2) Turntheignitionon,theLEDwillflashonce,thengoout.
3) Holddowntheresetbuttonfor3secondsandthenreleaseit.
4) Performactionrequiredforyourparticularvehicleasnotedinthe
vehicleinfosheet.
5) AfteracoupleofsecondstheLEDshouldstopflashingandnotlight
upfor2seconds.Atthispointdonotpushanybuttons.
6) Afterthe2secondstherewillbeaseriesof7Greenflashes,some
shortandsomelong.
7) TheLEDwillpauseforanother2secondsthenflashRedupto11
times(refertoASWC-1ledgend).
8) Thisistheendoftheautodetectionstage.IftheASWC-1detected
thevehicleandtheradiosuccessfullytheLEDwilllightupsolid.
9) ForvehicleswithOEBluetoothbuttonspleasepress“Hangup”
or“Pickup”onyoursteeringwheelcontrolaftertheLEDonthe
ASWC-1goessolid.IftheOEBluetoothbuttonsareabletobeused,
theLEDwillgooutafter3seconds.
YourOEBluetoothbuttonsare
nowprogrammedtoyouraftermarketradiosBluetoothbuttons
(aftermarketradiomusthaveBluetoothcapabilities).
Tip: If the LED does not light up solid refer to the
troubleshooting section.
10)Makesurethesteeringwheelcontrolbuttonsfunctioncorrectlyin
thevehicleandenjoy.
Section 2: Programming