Installation manual

20
Dual Assignment Instructions
Note: Seek up and Seek down are already set to Preset up and
Preset down for long press.
1) Turnontheignitionbutdonotstartthevehicle.
2) Pressandholddownthesteeringwheelbuttonthatyouwantto
assignalongpressfunctionto,forabouttensecondsuntiltheLED
rapidlyflashesgreen.AtthispointreleasethebuttonandtheLED
willgosolidgreen.
3) PressandreleasetheVOLUMEUPbuttonthenumberoftimes
correspondingtothenewbuttonnumberyouselected(seechart
below).ThegreenLEDwillblinkrapidlywhentheVOLUMEUPis
pressedandbacktosolidgreenwhenreleased.(Caution,ifmore
thantensecondselapsesbetweenaVOLUMEUPbuttonpress,this
procedurewillabort,andtheLEDwillgooff).Gotothenextstep
whentheVOLUMEUPbuttonhasbeenpressedthedesired
numberoftimes.
4) Tostorethelongpressbuttoninmemory,pressthebuttonthatyou
assignedalongpressbutton(thebuttonhelddowninstep1).The
LEDwillnowgooffindicatingithasbeenstored.
Note: These steps must be repeated for each button you would like
to assign dual purpose action to.
Toresetabuttonbacktoitsoriginaluse,repeatstep1above.Then
presstheVOLUMEDOWNbutton.TheLEDwillgooffandthelongpress
mappingforthebuttonwillbeerased.