Installation manual

10
Auto Detect Mode
SoyoutriedtheautodetectfeatureandattheendtheLEDdid
notstaysolid“red”.Insteaditstartedflashing,meaningthattheASWC-1
didnotdetectthevehicle.
Followthesestepstodeterminewhatmayhavehappened:
1) Verifythatyouhave12-voltaccessoryandagoodgroundto
theASWC-1.Sometimesthefactorygroundisnotsufficient,a
chassisgroundishighlyrecommended.IfyourvehiclehasaSWC
referencegroundwire,chassisgroundthataswell,alongwithyour
aftermarketradio.
2) Validateusingthevehicleinformationsheet(Axxesswebsite)that
thecorrectsteeringwheelcontrolwire(s),inthevehicle,were
connectedtothecorrectwire(s)totheASWC-1.
3) Confirmthatthe3.5mmconnectorisconnectedtoyourradio
securelyandinthecorrectlocation.
4) Ifusingthefemale3.5mmconnectorinEclipse,Kenwood,
selectJVC,orMetraOEradiosverifythattheradio’sSWCwireis
connectedtothecorrectwiretotheASWC-1.
Manual Programming Auto Detect Mode
IfyourvehicleisnotlistedforautodetectionbytheASWC-1onthe
Axxesswebsite,www.axxessinterface.com,youcanmanuallyprograma
non-datavehiclebythefollowingsteps(haveASWC-1legendavailable).
Section 3: Troubleshooting