CD Receiver Installation & Owner's Manual USB Port iPod®/iPhone®/Flash Drive HFP/A2DP/AVRCP SDHC Supported XDMA7200 CD CD-R/RW Compatible Aux 3.
XDMA7200 Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started • Remove trim ring from unit. • Insert the supplied keys into the slots as shown, and slide the unit out of the mounting sleeve.
XDMA7200 Wiring Diagram RCA Preamp Output Connections SUBWOOFER REAR FRONT Antenna Input Connect the vehicle antenna Steering Wheel Interface Input PAC SWI-PS connection (sold separately) 3.5mm BLUE BLACK RED YELLOW Bluetooth Microphone Input Connect the included Bluetooth microphone. Remote Turn-On Connect to amplifier or power antenna. Insulate wire if not used. Ground Connect to the vehicle chassis ground. Accessory Connect to an existing ignition circuit or switched 12 volt source.
XDMA7200 Receiver - Controls 1 20 2 3 19 4 18 Control Function 1 Mode 2 Audio/Menu 3 Select/Power 4 Mute 5 Bluetooth Talk 5 17 6 7 16 15 14 13 12 Accesses the audio adjustment options. Hold to access the setup menu. Activates music searches. Confirms menu options. Hold to turn the power off. Mutes the audio output. Answers phone calls. Accesses Number Dial, Recent Calls and Redial functions. Display Cycles displayed information. Hold to set the clock.
XDMA7200 IR Remote - Controls 1 2 3 4 5 21 6 20 7 19 8 18 9 17 10 16 11 15 12 14 13 1 Mode 12 Key 9/# Key 2 Select/Power 13 End Call 3 Volume Up 14 Key 0/Display 4 Audio/Menu 15 Talk 5 Tune/Track Up 16 Key 7/* Key 6 Volume Down 17 Key 8/Band 7 Mute 18 Preset 4/Play/Pause 8 Preset 2/Random 19 Preset 1/Repeat 9 Preset 3/Intro 20 Back 10 Preset 6/Folder Up 21 Tune/Track Down 11 Preset 5/Folder Down 5
XDMA7200 General Operation Faceplate Removal Power On/Off Source Press RELEASE to fold down the front panel. While pushing the front panel left, pull the right side away to remove. To reinstall, slide in bottom left side, then snap left side up and into place. Press or any other button to turn unit on. Press and hold to turn unit off. Press MODE to select between AM/FM, CD, auxiliary input, operation of iPod, USB, SD and Bluetooth modes. Modes of operation are indicated in the display.
XDMA7200 Setup Menu Press and hold AUDIO/MENU for more than 3 seconds to access the setup menu, then press AUDIO/MENU to cycle through menu options. When desired option appears in the display, rotate the volume knob left/right to adjust or activate desired function. Press BACK to exit any menu or submenu. Function Options Action Auto Station Store AUTO PGM STATIONS Press SELECT to begin automatically programming strong radio stations to the 6 preset buttons in the current band.
XDMA7200 Audio Menu Press AUDIO/MENU momentarily to cycle between Bass, Treble, Balance, Fader, Equalizer, Subwoofer, High Pass Filter and Source Volume Level. Press BACK at any time to exit the audio menu. BASS TREBLE BALANCE FADER EQ SUBWOOFER SOURCE LEVEL Bass Press AUDIO/MENU until BASS appears, then rotate the volume knob left/right to adjust (-6 minimum / +6 maximum). Treble Press AUDIO/MENU until TREBLE appears, then rotate the volume knob left/right to adjust (-6 minimum / +6 maximum).
XDMA7200 LCD Icon Layout Stereo FM Reception Repeat Loudness Tuner Random Operation of iPod Aux SD Card USB Phone Call Bluetooth CD-in Artist Name File Name Song Title Album Name Folder Name AM/FM Tuner Operation Seek Tuning Manual Tuning nn ll for more than one second Press TUNE nn or TUNE ll momentarily to move radio frequency up or down one step at a time. Press and Press TUNE or TUNE to seek the next strong station. hold to advance quickly.
XDMA7200 CD Player Operation - Audio CDs Insert CD Fold down front panel to access the CD slot. With the label facing up, insert a standard size CD into the CD slot. The CD will automatically begin playback. Eject CD Fold down front panel and press EJECT to eject the CD. The unit will change to previous mode of operation. If the disc is not removed within 10 seconds, the unit will reload the disc. The unit does not have to be turned on to eject CD.
XDMA7200 CD Player Operation - MP3/WMA Playing an MP3/WMA Disc Folder Access When an MP3/WMAencoded disc is first inserted, “READING” will appear in the display. Depending on the number of files and folders, this may take several seconds. Press Press to select the next folder. to select the previous folder. *Folder access is only available on discs recorded with more than one folder.
XDMA7200 CD Player Operation - MP3/WMA File/Folder Search Begin Searching Press SELECT to enter the file/folder search mode. A list of all the folders from the CD will be displayed. Note: Any files located in the root directory will be located in the folder named "ROOT". Choose a song Menu Navigation Playing a song Turn the volume knob to cycle through all the folders on the CD and press SELECT to choose the desired folder. The list of files in the selected folder will be displayed.
XDMA7200 CD Player Operation - MP3/WMA File/Folder Compatibility and Support Type Compatible File Types Incompatible File Types Recording Format Compatibility Sampling Frequency Rate Compatibility Transfer Bit Rate Compatibility Character Support ID3 Tag Support File/Folder Limit Specification • CD-ROM (ISO), CD-R, CD-RW • CD-DA (digital audio) • MP3 data (.mp3) • WMA data (.
XDMA7200 Operation of iPod/iPhone Connecting an iPod/iPhone Device USB Connection Using the "dock connector to USB" sync cable (provided with the iPod/iPhone device), plug the USB cable the XDMA7200's USB port. Once connected, playback will begin automatically.
XDMA7200 Operation of iPod/iPhone Controlling a Device: Full Control - Music Search The XDMA7200 features a powerful music search that simplifies the searching process. Follow the steps below to find the desired song: Begin Searching Select a Category Press SELECT to begin the search. The main search menu will appear. Turn the volume knob to select between playlist, artist, album, song, podcast and audiobook. Press SELECT to select the desired search category.
XDMA7200 Operation of iPod/iPhone Controlling a Device: Manual Control When the control of iPod/iPhone feature is set to "MANUAL" in the iPod Menu, use the following functions to control the device: Manual Control for iPod When "MANUAL" control for iPod is selected from the Setup Menu, the iPod or iPhone device can be controlled directly from the device's interface. All functions except for volume can be used from the iPod or iPhone device.
XDMA7200 USB/SD Card Operation Connect a USB Device (sold separately) To play MP3/WMA files from most mass storage devices, connect a device to the XDMA7200's USB port. Connect an SD Card (sold separately) To play MP3/WMA files from an SD Card, insert an SD card into the XDMA7200's SD card slot, located behind the front panel. Insert the SD card with the label facing to the left, and press the card until it clicks into place. Remove the SD card by pressing in until it clicks, then pull to remove.
XDMA7200 USB/SD Card Operation File/Folder Search Begin Searching Press SELECT to enter the file/folder search mode. A list of all the folders from the USB device will be displayed. Note: Any files located in the root directory will be located in the folder named "ROOT". Choose a song Turn the volume knob to cycle through all the folders on the device and press SELECT to choose the desired folder. The list of files in the selected folder will be displayed.
XDMA7200 USB / SD Card Operation File/Folder Compatibility and Support Type Specification • MP3 data (.mp3) Compatible File Types • WMA data (.
XDMA7200 Bluetooth® Operation Pairing a Device Preparation Pairing a New Device Before you can use a Bluetooth device, it must be paired and connected. Make sure that Bluetooth is activated on your device before you begin the pairing process. The XDMA7200 broadcasts the pairing signal constantly when no devices are currently connected. Complete the pairing sequence from your Bluetooth device. Refer to the owner's manual for your device for more details.
XDMA7200 Bluetooth® Operation Making a Phone Call Manual Dialing • Press once. "Enter Number" will be shown, then an "_" will appear on the display. • Using the remote control, enter the phone number using the 0-9 buttons. Press on the remote control or XDMA7200 front panel to begin dialing. Note: Placing a phone call from your cell phone will also use the Bluetooth function of the XDMA7200.
XDMA7200 Bluetooth® Operation During a Phone Call Volume Microphone Mute Turn the volume knob to adjust the volume level during a phone call. Bluetooth mode has a separate volume level from the main volume of other modes. The XDMA7200 will remember the volume level in Bluetooth mode and always return to the last volume level for each phone call. Press MUTE during a phone call to turn the XDMA7200's external microphone off. Press MUTE again to resume microphone operation.
XDMA7200 Bluetooth® Operation Streaming Audio Operation The XDMA7200 supports A2DP (advanced audio distribution profile) wireless streaming audio from your Bluetooth mobile device directly to your head unit. You can also control your music from the front panel of the head unit using AVRCP (audio video remote control profile). Notes: • To stream music to your head unit, your mobile device must support the A2DP and AVRCP Bluetooth profiles. Check the owner's manual of your mobile device for details.
XDMA7200 Limited One Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. What to do? 1. Before you call for service, check the troubleshooting guide in your owner’s manual. A slight adjustment of any custom controls may save you a service call. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. 2.
XDMA7200 Troubleshooting - General Problem Unit will not turn on (no power) Unit has power (but no sound) Unit blows fuses Excessive Skipping ERROR-02 appears on display CD will not eject PROTECT appears on display Cause Action Yellow wire not connected or incorrect voltage Red wire not connected or incorrect voltage Black wire not connected Fuse blown Speaker wires not connected Check connections for proper voltage (11-16VDC) One or more speaker wires touching each other or touching chassis ground
XDMA7200 Specifications FM Tuner Tuning range: 87.5MHz - 107.9MHz Usable sensitivity: 8.5dBf 50dB quieting sensitivity: 10dBf Stereo separation @ 1kHz: 40dB Frequency response: 30Hz - 13kHz AM Tuner Tuning range: 530kHz - 1710kHz Usable sensitivity: 22uV Frequency response: 30Hz - 2.2kHz General USB/SD Card Bluetooth® Profiles Speaker output impedance: 4 to 8 ohms Line output voltage: 2 Volts RMS Dimensions: 7" x 7" x 2" (178 x 178 x 51 mm) File system: FAT, FAT32 File extensions support: .mp3, .
XDMA7200 FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Dual Electronics Corp. Toll Free: 1-866-382-5476 axxera.dualav.com ©2011 Dual Electronics Corp. All rights reserved. iPhone, iPod, iPod classic, iPod nano, and iPod touch are trademarks of Apple Inc., registered in the U.S. and other countries. “Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to connect specifically to iPod or iPhone, respectively, and has been certified by the developer to meet Apple performance standards.
