Owner`s manual

26
X2DMA500
Bluetooth
®
Operation
MostBluetoothdevicessupporttheauto-connectfeature,andwillconnectautomatically
ifthedeviceisinrangewhentheX2DMA500ispowered-on.Ifyourdevicewaspreviously
pairedbutdoesnotconnect,usetheseinstructionsbelow.
•IfyourmostrecentlyconnectedBluetoothdevicebecomesdisconnectedordoesnot
reconnect,press fromBluetoothmodetoreconnectyourmobiledevice.
•Toconnectapreviouslypaireddevicethatwasnotrecentlyconnected:
1)Ifapplicable,pressandhold todisconnectanyconnectedmobiledevices.
2)FromBluetoothmode,pressSELECT."PairedDevices"willappearontheLCD.
3)Turnthetuningknobtocyclethroughthelistofdevices1through9.
4)PressSELECT or toconnecttothedesireddevice.Itmustbeinrangetoconnect.
Note:IftheAuto ConnectsetupmenusettingissettoOFF,youmustpress to
connectyoudeviceafterpairing,andeachtimetheX2DMA500ispowered-on.
Pressandhold
for3secondstodisconnectaconnecteddevice.Thedevicewillremain
pairedandappearinthePAIREDDEVICESmenu,butnotbeconnected.
BeforeyoucanuseaBluetoothdevice,itmustbepairedand
connected.MakesurethatBluetoothisactivatedonyour
devicebeforeyoubeginthepairingprocess.
TheX2DMA500broadcaststhepairingsignalconstantly
whennodevicesarecurrentlyconnected.Completethe
pairingsequencefromyourBluetoothdevice.Refertothe
owner'smanualforyourdeviceformoredetails.
The device name is "X2DMA500"
The Bluetooth passcode "1234"
Note:TheX2DMA500canbeinanymodeofoperation
whenpairingisperformed.
Ifadeviceiscurrentlyconnected,pressandhold to
disconnectthecurrentdevicebeforeanewdevicecan
bepaired.Thenbeginthepairingsequencefromthenew
Bluetoothdevice.
Preparation
Pairing a New Device
Pairing Additional
Devices
Pairing a Device
Connecting a Paired Device
Disconnecting a Device