User's Manual
Table Of Contents
- 1 Preface
- 2 AB-MAX Product Overview
- 3 Pre-Installation
- 4 Installing the Mounting Poles
- 5 Radio Installation
- 6 Installing the Interconnect Cables
- 7 Grounding the System
- 8 Installing the NIA/Power Adapter Hookup
- 9.0 Configuring the ABMAX Access Point Base Station
- Appendix A: Glossary of Terms and Abbreviations
ABMAX ACCESS POINT INSTALLATION AND MAINTENANCE GUIDE VERSION 1.1
32
OF 39
9.0 Configuring the ABMAX Access Point Base Station
9.1 Configure the Access Point with an IP identity
Use the following steps to configure each Access Point:
Follow this procedure to configure the Access Point using the Access Point browser-based setup
screens.
1) If the installer laptop is not running, power on and wait for the installer laptop to complete ini-
tialization to the desktop.
2) Set the PC IP address to be on the same network as the Access Point.
Note: Suggested to use config IP 10.1.1.2, netmask 255.255.255.0.
3) To run the Access Point setup operation, open an internet browser and type the following
default address in the browser Address field:
10.1.1.254
4) When the connection login popup appears, type the following in the user name/password
fields:
User Name: admin
Password: admin