User's Manual
Table Of Contents
- 1 Preface
- 2 AB-MAX Product Overview
- 3 Pre-Installation
- 4 Installing the Mounting Poles
- 5 Radio Installation
- 6 Installing the Interconnect Cables
- 7 Grounding the System
- 8 Installing the NIA/Power Adapter Hookup
- 9.0 Configuring the ABMAX Access Point Base Station
- Appendix A: Glossary of Terms and Abbreviations
ABMAX ACCESS POINT INSTALLATION AND MAINTENANCE GUIDE VERSION 1.1
16
OF 39
6) Align the mounting pole with the drilled holes and fix with the lag bolts.
Figure 4-3: Mounting Pole Installation
4.3 Installing On a Wall with Wood Siding
1) Place the mounting plate against the wall.
2) Using a level, be sure that the mounting pole is perpendicular to the ground. You may need to
use spacers, as shown in Figure 4-4.
3) Mark the hole locations for the drilled hole locations. Remove the mounting pole and set
aside.
4) Drill 1/8-inch holes in the places marked.
5) Use #10 or #12 wood screws to secure the mounting pole to the wall and tighten.
Figure 4-4 Mounting Pole on Clapboard Siding