Maintenance Guide

ABMAX CUSTOMER PREMISE EQUIPMENT INSTALLATION AND MAINTENANCE GUIDE VERSION 1.1
17
OF 42
Figure 4-4 Mounting Pole Installed on Pole or Antenna Mast
4.3 Installing On Brick or Masonry
1) Place the mounting plate against the wall (Figure 4-5). Use a level or plumb line to set the
mounting pole perpendicular to the ground.
2) Mark the hole locations.
3) Set the pole aside.
4) Drill ¼ inch holes at the marked locations. Drill the holes approximately ½ inch deep.
5) Insert the expansion shields into the drilled holes and tap them home.
6) Align the mounting pole with the drilled holes and fix with the lag bolts.
Figure 4-5 Mounting Pole Installation