Maintenance Guide

ABMAX CUSTOMER PREMISE EQUIPMENT INSTALLATION AND MAINTENANCE GUIDE VERSION 1.1
11
OF 42
3 Pre-Installation
3.1 Compliance Alert
The CE Marking with alert symbol (see below) appears on the Access Point assembly. The alert
symbol indicates operation on frequency bands that are not harmonized throughout the European
community.
Figure 3-1 Compliance Alert Labe
Note: This equipment operates in the 5 - 6 GHz frequency range, which is not harmonized
throughout the community.
Member states must be notified, in accordance with Article 6.4 of the R&TTE Directive 99/5/EC,
before this equipment can be sold or put into service. Contact Axxcelera Customer Support for an
up-to-date listing of Member State Notifications. See “Technical Support” on page 6.
3.2 Safety Precautions
PLEASE READ THESE SAFETY PRECAUTIONS!
3.2.1 RF Energy Health Hazard
Please pay attention to the following warnings:
When servicing equipment and selecting a location for the ABMAX antennas, it is important to note
that a minimum distance of 38 cm (15 inches) is required between personnel and ABMAX
antennas to comply with a radio-frequency exposure limit of 1.0mW/cm2.
Professional installation required. The radio equipment described in this guide uses radio
frequency transmitters. Although the power level is low, the concentrated energy from a
directional antenna may pose a health hazard. ABMAX integrated antennas are 16dBi.
3.2.2 Connection Sequence Caution
Arcing may occur when connecting the outdoor Ethernet cable to either the CPE or the NIA should
the power be connected to the NIA. Arcing may irrevocably damage the NIA or the CPE. To
prevent any chance of damage from occurring, verify that the power is disconnected from the NIA
before attempting to connect the interconnecting cable to either the CPE or NIA.