User's Manual

ABMAX CUSTOMER PREMISE EQUIPMENT INSTALLATION AND MAINTENANCE GUIDE VERSION 1.1
19
OF 42
5 Radio Installation
5.1 Before You Start
This section lists the information needed to install a CPE.
5.2 Information Required
Before you perform the installation, a site survey should have been performed by the service
provider. From this, you will need to know:
• Where the outdoor transceivers will be mounted (antenna mast, pole or building)
• Heights at which the outdoor transceivers will be mounted.
• Transceiver directional information (azimuth and elevation).
5.3 Installing the Equipment
This section explains how to install a CPE transceiver onto a variety of surfaces, connect them to
the indoor wallbox, and ground the system.
5.3.1 Installing the Outdoor Customer Premise Equipment
Now that you have installed the mounting pole, you are now ready to install the outdoor Customer
Premise Equipment (CPE) to the mounting pole. Table 5-1 describes the tools and equipment
needed to install the CPE.
Table 5-1 Required Tools and Equipment
1) Loosen the mounting screws and place the outdoor Customer Premise Equipment on the
mounting pole, as shown in Figure 5-1.
2) Hand tighten the mounting screws.
3) Rotate the outdoor transceiver in the direction of the Access Point.
4) Tighten the mounting screws.
Tools Equipment Quantity
Phillips-head screwdriver Pole clamp 2
3
/
16
” hex wrench
Washers 2
Mounting screws 2