Installation Manual
Table Of Contents
- 1 Preface
- 2 AB-MAX Product Overview
- 3 Pre-Installation
- 4 Installing the Mounting Poles
- 5 Radio Installation
- 6 Installing the Interconnect Cables
- 7 Grounding the System
- 8 Installing the NIA/Power Adapter Hookup
- 9.0 Configuring the ABMAX Access Point Base Station
- Appendix A: Glossary of Terms and Abbreviations
ABMAX ACCESS POINT INSTALLATION AND MAINTENANCE GUIDE VERSION 1.1
28
OF 39
8.1 Attaching to the Wall (optional)
Figure 8-5 Attaching to the wall
1) If the unit is to be wall mounted, mark two hole locations on an appropriate wall 23 mm (0.94
in.) apart.
2) Using the previously marked holes, screw two M4 pan head screws into the wall, leaving 3.18
mm (1/8 in.) minimum clearance between the head of the screw and the wall.
3) Position the NIA so that openings on the back line up with the screw heads.
4) Slide the NIA slots over the screw heads adjusting the exposed screw heads in or out for
appropriate tightness.
NIA
Pan Head screws for
wall mounting (not supplied)
Wall
Slot
2 places
Slot
2 places
5/9