Installation Manual
Table Of Contents
- 1 Preface
- 2 AB-MAX Product Overview
- 3 Pre-Installation
- 4 Installing the Mounting Poles
- 5 Radio Installation
- 6 Installing the Interconnect Cables
- 7 Grounding the System
- 8 Installing the NIA/Power Adapter Hookup
- 9.0 Configuring the ABMAX Access Point Base Station
- Appendix A: Glossary of Terms and Abbreviations
ABMAX ACCESS POINT INSTALLATION AND MAINTENANCE GUIDE VERSION 1.1
21
OF 39
6.3 Install the Interconnect Cables (Transceiver End)
1) Remove the grommet and clamping plate from the outdoor transceiver by removing the two
screws.
Figure 6-1: Grommet Location - Underside of Access Point
Note: The Grommet is made of a special conductive material used to complete the ground
between the Access Point and wallbox.
2) Insert the cable end through the grommet clamping plate (Figure 6-1:)
3) Insert the cable end through the grommet. The tapered end of the grommet should be
opposite the cable end.
4) Strip 1/2 inch of insulation off the cable end. Trim the wire ends flat as shown in Figure 6-2.
Figure 6-2 Outdoor Transceiver End of the Interconnect Cable with Cable Preparation