Installation Manual Part 2

Company Proprietary

Adaptive Broadband

U-NII Product Installation Manual 05/29/2001

7-2

7.2 Installing Mounting Pole

Once you have selected a site for installing the outdoor transceiver/Subscriber Unit, determine

what type of surface you will use for your installation. Select from the following list:

• Installing on a Brick Or Masonry Wall

• Installing on a Wall With Wood Siding

• Installing on an Antenna Mast

The following sections describe the installation procedure for each of the above.

7.2.1 Installing on a Brick or Masonry Wall

Table 7-1 describes the tools and equipment needed when installing on a brick or masonry wall.

Table 7-1 Required Tools And Equipment

Tools Equipment Quantity

Power drill Mounting pole 1

¼ inch masonry drill bit Anchor sleeves 4

A bubble level or plumb line Lag bolts 4

Phillips head screwdriver or

power drill

Hammer or mallet 1

Adjustable wrench 1

1. Place the mounting plate against the wall.

2. Using a level, be sure that the mounting pole is perpendicular to the ground.

3. Using a pencil, mark the hole locations for the drilled hole locations (Figure 6-2).

Figure 7-2 Mounting Pole Drill Locations