Installation Manual Part 1

Company Proprietary
Adaptive Broadband
U-NII Product Installation Manual 05/29/2001
6-4
Warning! The mounting pole must be grounded. See
Grounding The System
in
Section 6.6.3.
6.5.3 Installing On An Antenna Mast
TBD: Update this section for AB-Access Extender
4. Position the mounting pole on the antenna mast.
5. Insert the U-bolts around the mast and through the holes in the mounting pole. Install a
washer and nut to each side of the threaded U-bolt and hand tighten. Repeat this step for the
second U-bolt.
6. Tighten nuts equally until mounting pole is secure and cannot rotate.
Figure 6-3 Mounting Pole Installed on Pole or Antenna Mast
6.5.4 Installing On Brick Or Masonry
7. Place the mounting plate against the wall. Use a level or plumb line to set the mounting pole
perpendicular to the ground.
8. Mark the hole locations.
9. Set the pole aside.
10. Drill ¼ inch holes at the marked locations. Drill the holes approximately ½ inch deep.
11. Insert the expansion shields into the drilled holes and tap them home.
12. Align the mounting pole with the drilled holes and fix with the lag bolts.
Typical 2 ½ inch