Installation Manual Part 1

Company Proprietary
Adaptive Broadband
U-NII Product Installation Manual 05/29/2001
6-3
Figure 6-1 Outdoor AB-Access Extender Components
6.4 Indoor Patch Panel
Figure 6-2 shows the Base Station Access Panel used as an indoor patch panel.
Figure 6-2 Access Panel used as Patch Panel
6.5 Installing The Equipment
This section explains how to install an EX transceiver onto a variety of surfaces, connect them to
the indoor junction box, and ground the system.
6.5.1 Overview
Following are the installation steps you will perform:
6. Install the mounting poles.
7. Mount the outdoor transceivers.
8. Mount the access panel.
9. Ground the outdoor transceivers and access panel
10. Connect the interconnect cables.
6.5.2 Installing The Mounting Poles
First install the mounting poles, on which you will mount the outdoor transceivers.
Bear in mind the direction in which the transceivers will point.
Attention! The mounting pole must be mounted in a vertical position. Failure to do so
may result in improper alignment of the outdoor transceiver. If you need to tilt the
transceiver down to avoid self-interference, you should use an (optional) tilt bracket.
AP/EX OUT
AP/EX
IN