Installation Manual Part 1

Company Proprietary
Adaptive Broadband
U-NII Product Installation Manual 05/29/2001
5-8
3. Route the cable.
5.6.2.2 Install the Interconnect Cables (Transceiver End)
1. Remove the grommet and clamping plate from the outdoor transceiver by removing the two
screws.
Figure 5-11 Grommet Location - Underside of Access Point
NOTE: The Grommet is made of a special conductive material used to complete
the ground between the Access Point and Access Panel.
2. Insert the cable end through the grommet clamping plate (Figure 5-11)
3. Insert the cable end through the grommet. The tapered end of the grommet should be
opposite the cable end.
4. Strip 1 inch of insulation off the cable end. Leave 3/8 inch of shielding showing and trim the
wire ends flat ½ inch from there.
5. Using a piece of 1 inch squared tinned copper foil, wrap the foil around the shield/braid and
sheath with the left edge aligned with the edge of the braid, as shown in the following
Figures 5-12 and 5-13.