Installation Manual Part 1

Company Proprietary
Adaptive Broadband
U-NII Product Installation Manual 05/29/2001
5-5
5.5.4 Installing On Brick Or Masonry
1. Place the mounting plate against the wall. Use a level or plumb line to set the mounting pole
perpendicular to the ground.
2. Mark the hole locations.
3. Set the pole aside.
4. Drill ¼ inch holes at the marked locations. Drill the holes approximately ½ inch deep.
5. Insert the expansion shields into the drilled holes and tap them home.
6. Align the mounting pole with the drilled holes and fix with the lag bolts.
Figure 5-5 Mounting Pole Installation
5.5.5 Installing On A Wall With Wood Siding
1. Place the mounting plate against the wall.
2. Using a level, be sure that the mounting pole is perpendicular to the ground. You may need
to use spacers, as shown in Figure 5-6.
3. Mark the hole locations for the drilled hole locations. Remove the mounting pole and set
aside.
4. Drill 1/8-inch holes in the places marked.
5. Use #10 or #12 wood screws to secure the mounting pole to the wall and tighten.
Figure 5-6 Mounting Pole on Clapboard Siding