Installation Manual Part 1

Company Proprietary
Adaptive Broadband
U-NII Product Installation Manual 05/29/2001
5-2
5.2.1 Equipment Required
Table 5-1 lists the tools and equipment you will need to install Access Points.
Table 5-1 Required Tools and Equipment
Tools Required Equipment Required
Compass and protractor ¼ inch grounding rod
Area map Grounding clamp
Phillips-head screwdriver Grounding wire
Flat-head screwdriver CAT5 cable
Hammer or mallet #6 wood screws
Power drill Cable clips
1/8 inch drill bit Anchor sleeves
¼ inch masonry drill bit RJ-45 connectors (plastic
bodied)
3/16 inch hex (Allen) wrench
or 10 mm
Bubble level or plumb line
Adjustable wrench
Wire snake (if routing cable
through interior walls)
Crimping tool (must be
specifically matched for the
RJ-45 connector used)
Wire stripper
Small wire cutters
Punch down tool
5.3 Access Points
Table 5-2 lists the main components of an Access Point.
Table 5-2 AP Components
Item Quantity Notes
Outdoor transceiver 1 See item 1 in Figure 5-2
Mounting pole 1 See item 2 in Figure 5-2
Pole clamp 1 See item 3 in Figure 5-2
M6 washer 2 See item 4 in Figure 5-2
M3 x M10 machine thread screws 2 See item 5 in Figure 5-2
Grounding lug 2 See item 6 in Figure 5-2
Indoor junction box 1 6-way rack-mounted unit
Power supply and cord 1