Installation Manual Part 1

Company Proprietary
Adaptive Broadband
U-NII Product Installation Manual 05/29/2001
3-3
- Port 101 – connects the switch to an ATM25 card on the Control Server using an
ATM cross-over cable.
- The other ATM25 ports connect to each AP via the indoor junction box or
access panel, using ATM cross-over cable.
• Switch configuration ports:
- Console Port – Connects to the COM2 port on the Control Server. This is the usual
method for monitoring and configuring the switch. Standard serial port settings are 8,n,1
no flow control.
- Ethernet Port – Optionally, this can also be used to access the switch remotely.
You will need to give the switch an IP address, and then configure it via a machine
with an Ethernet card.
Please see the V-Switch User’s Guide (supplied with the switch) for detailed information on
configuring the switch.
• (Optional) Backhaul connection – This can be via:
- OC3
- DS3
- Multiple T1s.
- AB-Access Extender
3.5 Control Server
Figure 3-4 Dell 2450 Control Server Rear Panel
Shown in Figure 3-4 is the rear of a Dell PowerEdge 2450 Control Server. It comes pre-installed
with the necessary hardware to get a Base Station up and running. It provides an interface
Embedded Ethernet
NIC Interface
ATM25 port