Installation Manual Part 1

Company Proprietary
Adaptive Broadband
U-NII Product Installation Manual 05/29/2001
2-2
2.3 Required Tools and Equipment
This section lists all the extra tools and equipment mentioned in this guide that you will need to
perform the installation. None of the items listed in Table 2-1 are supplied with the kit, so make
sure you gather everything you need before you start. Use the table below to check exactly what
you will need (this will depend on where you are going to install the outdoor transceiver).
Table 2-1 Required Tools and Extra Equipment
TBD: add tool requirement for AB-Access Extender
Tools Required Extra Equipment Required
Compass ¼ inch grounding rod
Area map with an accurate direction
legend showing magnetic north
Grounding clamp
Phillips-head screwdriver Grounding wire
Flat-head screwdriver Roll of UTP CAT 5 cable
Hammer or mallet #6 wood screws
Power drill Cable clip
1/8 inch drill bit Anchor sleeves
¼ inch masonry drill bit RJ-45 connectors (plastic bodied)
3/16 inch hex (Allen) wrench 1 inch copper tape
Bubble level or plumb line Ethernet Hub (10BaseT)
Adjustable wrench
Wire snake (if routing cable through
interior walls)
Recommend a 19” rack to hold the
monitor, Element Management
System, Anchor Switch, and
Control Server.
Crimping tool (must be specifically
matched for the RJ-45 connector used)
Wire stripper
Small wire cutters
Punch down tool
2.4 Unpacking the Equipment
Table 2-2 lists all the standard parts that are supplied in your AB-Access Subscriber Unit
Installation Package. Please take the time to unpack the package
and check its contents against
this list.