Installation Manual
Table Of Contents
- 1 Preface
- 2 AB-MAX Product Overview
- 3 Pre-Installation
- 4 Installing the Mounting Poles
- 5 Radio Installation
- 6 Installing the Interconnect Cables
- 7 Grounding the System
- 8 Installing the NIA/Power Adapter Hookup
- 9.0 Configuring the ABMAX Access Point Base Station
- Appendix A: Glossary of Terms and Abbreviations
ABMAX ACCESS POINT INSTALLATION AND MAINTENANCE GUIDE VERSION 1.1
30
OF 39
3) Connect the two-wire power cord to the NIA. The power cord uses an IEC320-C7 type
connector (Figure 8-7 and Figure 8-8) Then insert the power cord connector from the NIA into
the nearest wall outlet.
Figure 8-7 Connect the power cord
Figure 8-8 Diagram of NIA’s IEC320-C7 type connector
Note: It is extremely important to connect the AC power to the NIA as the last step. Connecting AC
power prematurely can damage the CPE and lead to faulty behavior.