User's Manual
Table Of Contents
- 1 Preface
- 2 AB-MAX Product Overview
- 3 Pre-Installation
- 4 Installing the Mounting Poles
- 5 Radio Installation
- 6 Installing the Interconnect Cables
- 7 Grounding the System
- 8 Installing the NIA/Power Adapter Hookup
- 9.0 Configuring the ABMAX Access Point Base Station
- Appendix A: Glossary of Terms and Abbreviations
ABMAX ACCESS POINT INSTALLATION AND MAINTENANCE GUIDE VERSION 1.1
26
OF 39
8 Installing the NIA/Power Adapter Hookup
Install the ABMAX Access Point’s NIA/Power Adapter as follows:
1) Remove the new NIA/Power Adapter from the installation kit.
2) Flip the NIA over and use a Philips screw driver to remove the screw in Figure 8-1:
Figure 8-1: Remove access cover screw
Note: The NIA does not have a captive screw. Take care to retain this screw (Figure 8-2) when
opening the access cover on the adapter.
Figure 8-2 NIA access cover and non-captive screw