User's Manual
Table Of Contents
- 1.0 Preface
- 2.0 Introduction
- 3.0 Installation
- 3.1 Compliance Alert - Operation in the 3.4 - 3.6 GHz Band
- 3.2 Operation in the 3.650 - 3.675 GHz Band
- 3.3 Installation Warnings
- 3.4 Environmental Cautions
- 3.5 Installing Outdoor Equipment
- 3.6 Installing an Optional Sector Antenna
- 3.7 Installing Optional Omnidirectional Antenna
- 3.8 Installing the Access Point
- 3.9 Power and Data Connections - AC and DC Power Options
- 4.0 Configuring an Access Point for Single-Channel Use
- 5.0 Maintenance Guide
- Appendix A: NIA/Power Adapter Specifications: Model # TR60A-POE-L
- Appendix B: ExcelMax DC PSU/NIA (020-44109-0802)
- Appendix C: Glossary of Terms and Abbreviations
EXCELMAX ACCESS POINT CELL INSTALLATION AND MAINTENANCE GUIDE VERSION 1.4
9
OF 65
2.0 Introduction
This chapter covers the following information:
• ExcelMAX Access Point Packing List
• ExcelMAX Access Point Overview
• Major Components
2.1 ExcelMAX Access Point Packing List
The Access Point kit includes:
• 1 Access Point
• 1 L-bracket
• 1 clamp
• 1 U-bolt
• 1 PG-11 cable gland
• 1 PG-11 cable gland o-ring
• 1 ground lug
• 5 hex head bolts, M6 x 16 mm Lg
• 5 M6 split lock washers
• 1 M6 flat washer
• 2 M6 serrated flange nut
• GPS antenna (optional)
• 1 AC or DC NIA/Power Adapter (power cable n
ot included, supplied by the service provider*)
* AC power cables
are included
2.2 ExcelMAX Access Point Overview
ExcelMAX Access Points contain modem and radio circuitry that connects to an external
sector
ized or omnidirectional antenna. The antenna is designed for mounting on a standard
communications tower or on a building rooftop, and requires minimal “real estate.” The Access
Point connects to the local network device (switch/router) via a standard 10/100BaseT interface.
The antenna is connected to the Access Point v
ia 50-ohm low loss coaxial cable.
Some ExcelMAX Access Points also cont
ain GPS circuitry that connects to a separate supplied
external antenna (supplied by Axxcelera). The antenna is designed for mounting on a standard
communications tower or on a building rooftop, and requires minimal “real estate.”
The ExcelMAX Management System is typically located
at the customer Network Operating
Center (NOC), and allows complete control of the Axxcelera ExcelMAX system singly or in a
network environment