User's Manual
Table Of Contents
- 1.0 Preface
- 2.0 Introduction
- 3.0 Installation
- 3.1 Compliance Alert - Operation in the 3.4 - 3.6 GHz Band
- 3.2 Operation in the 3.650 - 3.675 GHz Band
- 3.3 Installation Warnings
- 3.4 Environmental Cautions
- 3.5 Installing Outdoor Equipment
- 3.6 Installing an Optional Sector Antenna
- 3.7 Installing Optional Omnidirectional Antenna
- 3.8 Installing the Access Point
- 3.9 Power and Data Connections - AC and DC Power Options
- 4.0 Configuring an Access Point for Single-Channel Use
- 5.0 Maintenance Guide
- Appendix A: NIA/Power Adapter Specifications: Model # TR60A-POE-L
- Appendix B: ExcelMax DC PSU/NIA (020-44109-0802)
- Appendix C: Glossary of Terms and Abbreviations
EXCELMAX ACCESS POINT CELL INSTALLATION AND MAINTENANCE GUIDE VERSION 1.4
47
OF 65
3.9.2.2 Completing the Connection of the DC Power Supply/NIA
1) In
sert one end of an RJ-45 to RJ-45 Ethernet cable assembly to the RJ-45 receptacle, labeled
Data, on the outside of the DC PSU/NIA and the other end to the customer's computer (Figure
3-24:).
Figure 3-24: Connect customer computer or network device
2) Check to see that the connection to the Access Point is in place.
Warning
It is extremely important to connect the DC power to the DC PSU/NIA as the last
step. Connecting DC power prematurely can damage the Access Point and lead to
faulty behavior.
Note
The DC PSU/NIA does not come with cables or
power cord. Service provider must
provide their own cables and power cord.
Note
Custome
r equipment requiring Ethernet connectivity may not be located more than
100 m (328 ft.) from the Access Point.
N
N