User's Manual
Table Of Contents
- 1.0 Preface
- 2.0 Introduction
- 3.0 Installation
- 3.1 Compliance Alert - Operation in the 3.4 - 3.6 GHz Band
- 3.2 Operation in the 3.650 - 3.675 GHz Band
- 3.3 Installation Warnings
- 3.4 Environmental Cautions
- 3.5 Installing Outdoor Equipment
- 3.6 Installing an Optional Sector Antenna
- 3.7 Installing Optional Omnidirectional Antenna
- 3.8 Installing the Access Point
- 3.9 Power and Data Connections - AC and DC Power Options
- 4.0 Configuring an Access Point for Single-Channel Use
- 5.0 Maintenance Guide
- Appendix A: NIA/Power Adapter Specifications: Model # TR60A-POE-L
- Appendix B: ExcelMax DC PSU/NIA (020-44109-0802)
- Appendix C: Glossary of Terms and Abbreviations
EXCELMAX ACCESS POINT CELL INSTALLATION AND MAINTENANCE GUIDE VERSION 1.4
34
OF 65
The strap is then connected to the tower. The clamp is wound with waterproof tape.
3.7.5 Waterproofing Cable Connections
Wrap RF cable connections with waterproof tape.
3.8 Installing the Access Point
3.8.1 Mounting L-bracket to the Access Point
Figure 3-13: Mounting the L-bracket to the Access Point
1) Attach the L-bracket to the Access Point using 4 hex bolts with 4 split lock washers.
2) Torque the hex bolts to 8.81 ±67 Nm (78 ±6 in.-lb.) with a 10 mm open-end wrench.
M6 X 16 mm Hex Bolt
4 ea
M6 Split Lock Washer
4 ea