User's Manual
Table Of Contents
- 1.0 Preface
- 2.0 Introduction
- 3.0 Installation
- 3.1 Compliance Alert - Operation in the 3.4 - 3.6 GHz Band
- 3.2 Operation in the 3.650 - 3.675 GHz Band
- 3.3 Installation Warnings
- 3.4 Environmental Cautions
- 3.5 Installing Outdoor Equipment
- 3.6 Installing an Optional Sector Antenna
- 3.7 Installing Optional Omnidirectional Antenna
- 3.8 Installing the Access Point
- 3.9 Power and Data Connections - AC and DC Power Options
- 4.0 Configuring an Access Point for Single-Channel Use
- 5.0 Maintenance Guide
- Appendix A: NIA/Power Adapter Specifications: Model # TR60A-POE-L
- Appendix B: ExcelMax DC PSU/NIA (020-44109-0802)
- Appendix C: Glossary of Terms and Abbreviations
EXCELMAX ACCESS POINT CELL INSTALLATION AND MAINTENANCE GUIDE VERSION 1.4
33
OF 65
3) Attach the RF cable. Torque the connector to 1.7 Nm (15 in.-lb.).
Figure 3-12: Attach cable to Access Point
3.7.3 Attaching RF Cable to Access Point
1) Attach the RF cable to the Access Point.
2) Torque the connector to 1.7 Nm (15 in.-lb.).
3) Seal the connection.
3.7.4 Grounding the Cables
Ground the RF cables in accordance with the manufacturer’s specification. Ground the cables at
the top of the tower.
Grounding methods may vary from site to site and with the manufacturer’s recommendations.
One method of grounding is to strip the cover fro
m the low-loss cable and clamp a ground strap to
the exposed copper shield.