User's Manual
Table Of Contents
- Revision History
- PLEASE READ THESE SAFETY PRECAUTIONS!
- Document Overview
- AB-Access Overview
- AB-Access Reference Model
- Static Configurations
- CLIP_T
- CLIP_S
- Hybrid CLIP_S
- 1483_T
- 1483_S
- Native ATM
- Extender
- RF Design and Planning
- SNMP
- Rupee
- RTFD (Return To Factory Default)
U-NII Config & User Guide 5.2 Axxcelera Broadband Wireless
7 CLIP_S
The CLIP_S configuration is when the AP acts as an ATM switch and the SU acts as a
router. This means that the AP will pass ATM cells at layer 2, and the SU will act as a router
analyzing all data at layer 3 and based upon destination IP address forward the data out the
proper interface.
In static mode you can configure the management traffic in either routed or a switched
configuration. Each section describes the pros and cons of each configuration so you can
decide which is best for your network.
7.1 CLIP_S Interactive
All assumptions for troubleshooting CLIP_S are based on the following diagram.
192.168.2.100 /24
RL
BL
SL
A
RL
BL
SL
E
ATM Switch
Control Server
Router
192.168.5.1
192.168.3.65 /29
MID 0
LAN
PVC
35
192.168.5.5
PVC
36
SU Management PVC
SU Data PVC
PVC
36
atm0 192.168.2.1 /24
192.168.2.50 /24
PVC
33
PVC
33
AP Management PVC
PVC
61
PVC
32
AP Registration PVC
March 10, 2003 Company Confidential Page 54 of 149