User's Manual

U-NII Config & User Guide 5.2 Axxcelera Broadband Wireless
6.4.3.2 SU2 system.conf
channel 0
antenna horizontal
mode static
mid 4
bid 0
interface eth0
duplex half
backoff 0
provider abw
key Axxcelera
mask 1ffff
leds active
6.4.4 Troubleshooting
6.4.4.1 Can’t ping the radio from the terrestrial interface
1.
Check all physical connections. The radio is a network device, which means if
you connect it to a PC (NIC) you will use a straight-through cable. To connect the radio to a
network device (hub, switch, router) use an Ethernet cross-over cable (1-3, 2-6). It is also
important to check that the cable is punched down correctly in the wall box and that the cable is
terminated correctly at the radio. The termination at the radio uses 568B
(wo,o,wg,bl,wbl,g,wbr,br).
2. Make sure the computer you are pinging from is on the same network as the AP.
If you are on a different network than the radio make sure you have the proper routes in the
radio and the computer you are trying to ping from.
6.4.4.2 Can’t ping across the wireless link
There are numerous reason why you couldn’t ping across the wireless link. After
following these troubleshooting steps and you still can’t ping across the wireless link refer to the
RF troubleshooting document.
1. Check that SU has the proper MID.
192.168.3.65 hmm> system mid
MID 3
2. Check the “ipatm pvc” is correct in relation to the MID and remoteip
March 10, 2003 Company Confidential Page 52 of 149