User Guide

AB-Access Config & User Guide 5.5 Axxcelera Broadband Wireless
July 27, 2004 Company Confidential Page 51 of 129
6.3 initswitchcli
6.3.1 tp
tp name service pcr
Name
{name | default} Can be assigned a name or the default.
Service
{UBR | CBR | ABR | VBR} UBR is currently the only service
that is supported.
Pcr
{0-70000} Peak Cell Rate, used to define the maximum cells
arrival/transmission rat at/from the wireless interface (ATM cells per
second).
Example
TP (traffic parameter) sets the type of service that is desired and peak cell rate. The following
example show the TP default set to Unspecified Bit Rate with a Peak Cell Rate of 2667.
tp default UBR 2667
NOTE: When setting PCR for a bi-directional PVC the following applies.
atm25i – atm25m = terrestrial – wireless : which is the same as the tx in the ipatm pvc settings.
atm25m – atm25i = wireless – terrestrial : which is the same as the rx in the ipatm pvc settings.
6.3.2 sp
sp name buffer stats
name
{name | default} Can be assigned a name or the default.
buffer
{cells} Number of cells that can be buffered.
stats
{stats} Is optional, but needs to be used for the stats command
to work.
Example
SP (switch parameter) sets the size of the buffer in the switchcli and whether or not stats are
recorded. The following shows the buffer set to 256 cells and stats recording enabled. This should be
the default for all configs using the switchcli.