User Guide

AB-Access Config & User Guide 5.5 Axxcelera Broadband Wireless
July 27, 2004 Company Confidential Page 50 of 129
tx_watchdog 1
6.2.15 ptp
ptp mode
mode {enable | disable} Enables or disables the point-to-point power
control. When enabled it will disable the power control algorithm that
controls the uplink txpower from an SU. With this enabled the SU will
tx at maximum power, which should help the uplink PER on PTP
links.
Example
The following example sets the ptp to enable.
ptp enable
6.2.16 dfs
dfs mode
mode {enable | disable} Enables or disables the dynamic frequency
allocation. Dynamic Frequency Allocation allows the AP to change to
a clean channel if interference is detected on its current channel. This
feature is only available on FPGA units.
Example
The following example sets the dfs to enable.
dfs enable
6.2.17 dfs_threshold
dfs_threshold dBm
dBm {-30 - -85} Sets the received signal level threshold of an
interferer which will cause the AP to change channels.
Example
The following example sets the dfs_threshold to -40 dBm.
dfs_threshold -40