User Guide
Table Of Contents
- Revision History
- PLEASE READ THESE SAFETY PRECAUTIONS!
- Document Overview
- AB-Access Overview
- AB-Access
- RF Design and Planning
- Static Configurations
- CLIP_T
- CLIP_S
- Hybrid CLIP_S
- 1483_T
- 1483_S
- Native ATM
- Extender
AB-Access Config & User Guide 5.5 Axxcelera Broadband Wireless
July 27, 2004 Company Confidential Page 38 of 129
5.11.2
Six-Sector, Six-Frequency Plan
This plan is good for Microcells or Macrocells on uneven terrain:
• Use 1 channel guardband/separation between sectors (U-NII & ISM only)
• Use opposite polarization in opposite directions
• Use 4 meter separation (or equivalent isolation)
• Use >1 meter separation between sectors
• Use a different set of three frequencies on alternating cells.
Single closest
interfering sector
61
3
2
4
5
6 Frequency Reuse
f1
f2
f3
HP
VP
f4
f5
f6
Sector
Numbering
Single closest
interfering sector
61
3
2
4
5
6 Frequency Reuse
f1
f2
f3
HP
VP
f4
f5
f6
Sector
Numbering
5.12
Antenna Spacing
In most Base Station deployments, multiple APs are placed on a single building or tower. To
minimize AP to AP interference, it is necessary to mount the antennas with proper spacing. Based on
the frequency plan identified, the following minimum spacing shown in the table below should be
maintained.