User Guide
Table Of Contents
- Revision History
- PLEASE READ THESE SAFETY PRECAUTIONS!
- Document Overview
- AB-Access Overview
- AB-Access
- RF Design and Planning
- Static Configurations
- CLIP_T
- CLIP_S
- Hybrid CLIP_S
- 1483_T
- 1483_S
- Native ATM
- Extender
AB-Access Config & User Guide 5.5 Axxcelera Broadband Wireless
July 27, 2004 Company Confidential Page 119 of 129
13 Extender
The Extender (PTP) units operate in the same manner as the AB-Access (PMP) units.
The Ethernet Extender configuration and operation are almost identical to the 1483_T
configuration except they use a single port bridge which is more efficient.
The ATM Extender configuration and operation is identical to the Native_ATM configuration,
where as the AP and the SU act as an ATM switch. Both AP and SU will pass any ATM cells without
looking at upper level protocols.
BHM = Backhaul Master
BHS = Backhaul Slave
13.1
Ethernet Extender
All assumptions for troubleshooting the Ethernet Extender are based on the following diagram.