Trouble Shooting Guide
Table Of Contents
- Troubleshooting-Installing an RF link
- Issue : 5.3.x
- Authors : Matt Olson/Dave Sida
- Date : 30th July 2004
- CONTENTS
- CHANGE HISTORY
- INTRODUCTION
- Aligning an SU
- Fine tuning an SU
- SU signal quality
- Troubleshooting SU link from AP
- Link status
- AP Link Status
- SU Link Status
- MAC type
- Unit MAC address
- Channel
- Radio Channel Mask
- Correlation sequence
- MAC delay compensation
- Unit Range
- Base Station ID
- Radio Temperature
- RSSI
- Path loss in excess of FSL (estimate)
- Downlink RSSI Fade Margin
- TX maximum backoff
- TX current backoff
- Max TX power for channel
- Actual TX power
- Averaging MAC error rates over
- Downlink Header Error Rate
- Downlink Cell Error Rate
- Uplink Cell Error Rate
- Modem RSSI
- Mac stats
- Modem txpower
- Modem mmse
- PNMS Sector
- Survey Scan
- Modem msreg 6 1
- Modem rxdc stats
- Bun list channels
Axxcelera Broadband
Troubleshooting-Installing an RF link - 35 - Issue: 5.3.x
Rev 2
12 PNMS Sector
The pnms status command retrieves the RF related stats from an entire sector with one command. It is only
available on an AP. It scans the sector up to MID <n> and display results for each SU that responds.
Values are updated every 10 minutes and are only updated when there is sufficient traffic to make the
calculations meaningful. For the first 10 minutes the unit is powered up the values will be zero.
AP pnms sector
192.168.2.2> pnms sector 5
Sector Status
-------------
MID search : 1 2 3 4 5
IP address RSSI downstream upstream
min max now error % error %
192.168.2.254 -45.738 -45.738 -45.738 0.132 0.000