Install Manual

Axxcelera Broadband Product Install Manual Page 53 of 71
3. Remove the mounting pole and set it aside.
4. Drill 1/8 inch diameter in the places marked.
5. Use #10 or #12 wood screws to secure the mounting pole to the wall and hand tighten.
6. Using the level, check that the mounting plate is perpendicular to the ground. Readjust if
necessary (you might need to add or remove spacers) and then tighten all screws with a
screwdriver or power drill, being careful not to over tighten.
Figure 6-4 Mounting Pole on Clapboard Siding
6.2.3 Installing on an Antenna Mast
Table 6-3 describes the tools and equipment needed when installing on an antenna mast.
Table 6-3 Required Tools and Equipment
Tools Equipment Quantity
Adjustable wrench U-bolts 2
Washers 4
Hex nuts 4
1. Position the mounting pole on the pole or antenna mast (Figure 6-5).
2. Insert the U-bolts around the pole and through the holes in the mounting pole.
3. Install a washer and nut to each side of the threaded U-bolts and hand tighten.
Figure 6-5 Mounting Pole Installed on Pole or Antenna Mast
4. Tighten nuts equally until mounting pole is secure and cannot rotate.