Install Manual

Axxcelera Broadband Product Install Manual Page 51 of 71
• Installing on an Antenna Mast
The following sections describe the installation procedure for each of the above.
6.2.1 Installing on a Brick or Masonry Wall
Table 6-1 describes the tools and equipment needed when installing on a brick or masonry wall.
Table 6-1 Required Tools And Equipment
Tools Equipment Quantity
Power drill Mounting pole 1
¼ inch masonry drill bit Anchor sleeves 4
A bubble level or plumb line Lag bolts 4
Phillips head screwdriver or
power drill
1
Hammer or mallet 1
Adjustable wrench 1
1. Place the mounting plate against the wall.
2. Using a level, be sure that the mounting pole is perpendicular to the ground.
3. Using a pencil, mark the hole locations for the drilled hole locations (Figure 6-2).
Figure 6-2 Mounting Pole Drill Locations
4. Set the mounting pole aside.
5. Using a ¼ inch masonry drill bit, drill holes approximately ½ inch deep at the marked
locations.
6. Insert the anchor sleeves into the drilled holes. Using a small hammer, gently tap the anchor
sleeves into the masonry until tight. Check that the anchor sleeves are flush with the wall.
(Figure 6-3)
7. Align the mounting pole with the drilled holes.