Install Manual

Axxcelera Broadband Product Install Manual Page 46 of 71
Figure 5-12 Interconnect Cable Connections to Indoor Junction Box
10. Snip off excess wire ends, if necessary.
Attention! Avoid excessive wire loops when connecting the wire to the punch down block.
For now, set the junction box to one side leaving it disassembled. You will reassemble it and
mount it on the wall when you have grounded the system.
5.5.1.4 Mark the AB-Extender Cables
Attention! Step 1 is important, and will enable the network installer to configure the
system easily.
1. Mark the cable with a permanent label and make a note so that the network installer knows
which outdoor EX transceiver is connected to which port on the Access Panel junction box.
5.6 Grounding the System
The AB-Access System must be properly grounded in order to protect it and the structure it is
installed on from lightning damage. This requires:
1. Grounding all the outdoor transceivers as shown in Figure 5-11.
2. Grounding the Access Panel to the rack.