Install Manual

Axxcelera Broadband Product Install Manual Page 45 of 71
10. Slide the grommet up the cable and press it into the bottom of the outdoor EX.
11. Slide the grommet clamp up the cable and align the holes with the mounting holes on the
bottom of the outdoor transceiver.
12. Insert the two screws in the mounting holes and tighten until the grommet has a slight bulge.
Be sure to tighten both screws equally so that the grommet is seated correctly.
13. Secure the interconnect cable to the mounting pole with the cable clip as shown in Figure 5-
11.
Figure 5-11 Interconnect Cable Installation to Outdoor AB-Extender - Bottom View
5.5.1.3 Installing The Interconnect Cables to Junction Box
Note that the junction box should still be disassembled and not screwed to the wall at this point.
6. Strip 2 inches of insulation off the junction box end of the interconnect cable.
Attention! Don’t cut off the shield from the cable – you will need it to ground the system
later.
7. Insert the cable end through the notched out section of the junction box.
8. Reinstall the PCB into the junction box using the two screws, allowing enough of the
interconnect cable to be able to reach the punch down block and wrap around the mounts of
the cover plate for strain relief.
9. Using Figure 5-12 as a guide, use the 110 punch down tool to punch down each wire into the
slot on the punch down block.