Install Manual

Axxcelera Broadband Product Install Manual Page 42 of 71
Figure 5-7 Tilt Bracket
Figure 5-8 AB-Extender with Mounted Tilt Bracket
5.5.1 Installing the Interconnect Cables
For each interconnect cable, you will need to perform the following steps.
5.5.1.1 Route the Cables
1. Select where the cable will enter the building from the outside.
2. Determine the length of cable required. Allow three extra feet on each end to allow for strain
relief, as well as any bends and turns.
3. Route the cable.
5.5.1.2 Install the Interconnect Cables (Transceiver End)