Install Manual
Table Of Contents
- Preface
- PLEASE READ THESE SAFETY PRECAUTIONS!
- Table of Contents
- List of Figures
- List of Tables
- AB-Access Product Overview
- Getting Started
- Base Station Installation
- Access Point Installation
- AB-Extender Installation
- Subscriber Unit Installation
- Indoor Junction Box
- Glossary
- Acronyms/Abbreviations
Axxcelera Broadband Product Install Manual Page 40 of 71
3. Set the pole aside.
4. Drill ¼ inch holes at the marked locations. Drill the holes approximately ½ inch deep.
5. Insert the expansion shields into the drilled holes and tap them home.
6. Align the mounting pole with the drilled holes and fix with the lag bolts.
Figure 5-3 Mounting Pole Installation
5.4.5 Installing On a Wall with Wood Siding
1. Place the mounting plate against the wall.
2. Using a level, be sure that the mounting pole is perpendicular to the ground. You may need
to use spacers, as shown in Figure 5-4.
3. Mark the hole locations for the drilled hole locations. Remove the mounting pole and set
aside.
4. Drill 1/8-inch holes in the places marked.
5. Use #10 or #12 wood screws to secure the mounting pole to the wall and tighten.
Figure 5-4 Mounting Pole on Clapboard Siding
5.5 Mounting the Outdoor AB-Extender
Now that you have installed the mounting pole, you are ready to install the AB-Extender onto the
mounting poles. Reference Figures 5-5 through 5-8.