Install Manual

Axxcelera Broadband Product Install Manual Page 39 of 71
5.4.1 Overview
Following are the installation steps you will perform:
1. Install the mounting poles.
2. Mount the outdoor transceivers.
3. Mount the access panel.
4. Ground the outdoor transceivers and access panel
5. Connect the interconnect cables.
5.4.2 Installing the Mounting Poles
First install the mounting poles, on which you will mount the outdoor transceivers.
Bear in mind the direction in which the transceivers will point.
Attention! The mounting pole must be mounted in a vertical position. Failure to do so
may result in improper alignment of the outdoor transceiver. If you need to tilt the
transceiver down to avoid self-interference, you should use an (optional) tilt bracket.
Warning! The mounting pole must be grounded. See Grounding The System in Section
4.5.3.
5.4.3 Installing On an Antenna Mast
1. Position the mounting pole on the antenna mast.
2. Insert the U-bolts around the mast and through the holes in the mounting pole. Install a
washer and nut to each side of the threaded U-bolt and hand tighten. Repeat this step for the
second U-bolt.
3. Tighten nuts equally until mounting pole is secure and cannot rotate.
Figure 5-2 Mounting Pole Installed on Pole or Antenna Mast
5.4.4 Installing On Brick or Masonry
1. Place the mounting plate against the wall. Use a level or plumb line to set the mounting pole
perpendicular to the ground.
2. Mark the hole locations.
Typically 2 ½
inch