Install Manual

Axxcelera Broadband Product Install Manual Page 28 of 71
2. Using a level, be sure that the mounting pole is perpendicular to the ground. You may need
to use spacers, as shown in Figure 4-5.
3. Mark the hole locations for the drilled hole locations. Remove the mounting pole and set
aside.
4. Drill 1/8-inch holes in the places marked.
5. Use #10 or #12 wood screws to secure the mounting pole to the wall and tighten.
Figure 4-5 Mounting Pole on Clapboard Siding
4.5 Mounting the Outdoor Access Points
Now that you have installed the mounting pole, you are ready to install the Access Points onto
the mounting poles. Reference Figures 4-6 through 4-9.
Figure 4-6 Mounting Parts for an Outdoor Access Point
1. Place the outdoor Access Point on the mounting pole.
2. Align the pole clamp with the mounting holes.
3. Insert the mounting screws and hand tighten.
4. Rotate the outdoor Access Point so it is pointing in the correct direction.