Install Manual

Axxcelera Broadband Product Install Manual Page 26 of 71
Figure 4-2 Outdoor Access Point Components
4.4 Installing the Equipment
This section explains how to install an AP transceiver onto a variety of surfaces, connect them to
the indoor junction box, and ground the system. The most likely scenario is to install six
transceivers on a single tower or mast 60 degrees apart.
4.4.1 Overview
Following are the installation steps you will perform:
1. Install the mounting poles.
2. Mount the outdoor transceivers.
3. Mount the access panel.
4. Ground the outdoor transceivers and access panel
5. Connect the interconnect cables.
4.4.2 Installing the Mounting Poles
First install the mounting poles, on which you will mount the outdoor transceivers.
Bear in mind the direction in which the transceivers will point.
Attention! The mounting pole must be mounted in a vertical position. Failure to do so
may result in improper alignment of the outdoor transceiver. If you need to tilt the
transceiver down to avoid self-interference in a cellular-style deployment, you should use
an (optional) tilt bracket.
Warning! The mounting pole must be grounded. See Grounding The System in Section
5.6.3.